Mug Stein 0,5L with lid

MUG STEIN WIDE WHITE 0,5L WITH PEWTER LID

Porcelain Beer Stein additionally with a pewter hinged lid against beer weathering

DIMENSIONS - WEIGHT

Diameter 99 / height 139mm  ( with hinged lid - 180mm)
Volume 24 oz   700ml / weight app 670g
Max. height of printed image app. 87mm

PACKAGING

Beer Steins are packed individually in a box
The total package contains 6 beer mugs

PRINT - TEMPERATURES - TIMES

CLASSICAL MUG PRESS
Use heater 900-Mug Stein Wide to the Mug Press BJ900 
Basic - Working Temperature: 140-160C ( 280-320F ) / 90 sec

Note Place the printed image at least 30 mm from the bottom of the Mug. In the Mug press, the lower edge is considerably cooled from the bottom of the Mug (which is outside the heater), ie the transferred image could have a lower contrast in the lower part. It is best to place the fixing tape down / up (not on the sides of the image)

3D OVEN / ST3042
Use : Silicon Wrap - Mug15oz / 400ml (the rubber expands a little bit)
Switch on both bottom and top heating, 195 C / 12-13 min
! The setting of each individual Press may vary slightly !

Note  For a larger Mug diameter (than Mug Big 15oz) it is necessary slightly to adjust clips 
Please bend both fixing ends of the clip away from each other so that when closing the clip by pulling it around the Mug, the clip will be securely locked, see last picture

When closing the clip, it is advisable to wrap a teflon foil around the Mug (above fixed image) so that the silicone clip glides better  when pulled around the mug and does not tend to move with fixed image