Mug Stein Wide White 0,5L

MUG STEIN WIDE WHITE 0,5L

Favourite Beerstein
Coating Orca - marked with the logo Orca on the bottom

DIMENSIONS - WEIGHT

Diameter 96 / height 136mm
Volume 22 oz   600ml / weight app 742g
Max. height of printed image app. 85mm
If the Mug has a molded (outer) line - gauge, max height of the image is about 75 mm

PACKAGING

Steins are sold individually
Case contains 18 Steins / 6pcs per 3 x carton / weight app. 15 kg
Packaging for one Stein (sold separately): Gift Box Mug Stein

PRINT - TEMPERATURES - TIMES

CLASSICAL MUG PRESS
Use heater 900-Mug Stein Wide to the Mug Press BJ900 
Basic - Working Temperature: 140-170C ( 250-345F ) / 80 sec
Note Place the printed image at least 30 mm from the bottom of the Mug. In the Mug press, the lower edge is considerably cooled from the bottom of the Mug (which is outside the heater), ie the transferred image could have a lower contrast in the lower part. It is best to place the fixing tape down / up (not on the sides of the image)

3D OVEN / ST3042
Use : Silicon Wrap - Mug15oz / 400ml (the rubber expands a little bit)
Switch on both bottom and top heating, 195 C / 14 min
! The setting of each individual Press may vary slightly !

Note  For a larger Mug diameter (than Mug Big 15oz) it is necessary slightly to adjust clips 
Please bend both fixing ends of the clip away from each other so that when closing the clip by pulling it around the Mug, the clip will be securely locked, see last picture

When closing the clip, it is advisable to wrap a teflon foil around the Mug (above fixed image) so that the silicone clip glides better  when pulled around the mug and does not tend to move with fixed image