Shrink Film Clip 10cm

SHRINK FILM CLIP WIDTH 10cm

Clip for fixing shrink film around the printed object.
The clip allows you to turn off the shrink film around the printed object so that you do not need to heat the film with a hot melt gun and you can immediately insert the entire assembly into the 3D / oven - easier and much faster

The picture shows 2 examples:

Travel mug 1200ml - the clip perfectly turns off / pulls the film around the fixed image
Enamel mug 180ml - the clip allows you to pull the film close to the hendle without the need to cut a hole for the handle.
The film is also pulled under the upper rim of the enamel mug, i.e. printing can be done close to the top edge and the handle !

INFO: There is a screw with a long nut on the clamp intentionally, in case the clamp does not hold the foil (which shrinks) during heating and tends to slip. In this case, the screw is a safety catch that hooks onto the ear of the printed object. If you use smaller clamps to fix objects without an ear, when the clamp does not grip the foil over the ear, but you need a full grip of the jaws - please remove the screw with the nut.

Clip width (length of clamping part) : 96mm
Weight : 75g

Clips are sold individually