Double wall beer glass

DOUBLE WALL BEER GLASS

The glasses are lightweight and made ​​of highly heat-resistant Vycor glass
Each glass is 100% handmade
Double wall design keeps the temperature of beverages, but temperature is not transmitted to the outer grip wall
It is not recommended to wash in the dishwasher

DIMENSIONS - WEIGHT

Diameter 90-60 / height 210mm
Volume 15 oz   400ml 
The thickness of the glass / wall 1,5 mm
Weight app 330 g
Recommended height of printed image app. 58mm, place image 10mm below top edge, print only the upper straight part

PACKAGING

Glasses are sold individually
2 glasses are packed in one box (see picture)
The whole case contains 24 glasses / weight app. 9 kg

PRINT - TEMPERATURES - TIME

GENERAL FOR GLASS - prepare a richer / contrasting image so that the max of ink is transferred to the coating and the image is clearly visible on the glass

CLASSICAL MUG PRESS BJ900
Use heater : Heater 900 - Mug Stein wide or Heater 900 - Enamel Cup 16oz
1st temperature          140°C
2nd temperature         170°C
Time :                        50 sec (countdown after reaching the 2nd temperature) 
Note:
A cold glass cannot be placed in a hot press, as there is a risk of the thin glass breaking!
Proceed as follows: Close the glass into the press when it is off = cold, set low pressure, turn on the press, set the temperature and time and heat the glass simultaneously with the press up to 140C, after the beep, start the print as usual

3D OVEN 
Use :  Silicon Wrap - Mug11oz / 300ml  or  Shrink foil THERMOS
ST3042 : Turn on the bottom and top heating 195°C / 9 min  
PD2800 :   
Note: The glass has a slight taper, i.e. after tightening, look from the inside of the glass to see if the bottom edge of the sublimation paper is actually touching the glass. It is advisable to put Teflon foil or paper under the tensioning rubber so that the dye does not seep into the silicone clip