Categories

Shrink foil CUTLERY

Shrink foil CUTLERY
Shrink foil CUTLERY
Previous keyboard_arrow_left
Next keyboard_arrow_right
Shrink foil CUTLERY
Shrink foil CUTLERY
Previous keyboard_arrow_left
Next keyboard_arrow_right

Shrink foil for printing polymer cutlery

0.08 € no VAT

0.08 € incl. VAT In stock 1 846 pcs

HEAT SHRINK FOIL (BAG) / CUTLERY  (2,7 x 11)

Shrink film for printing stainless steel cutlery with a polymer handle in 3D / oven

The heat shrink foil is intended for printing :

* Polymer kid's cutlery
* Polymer cutlery standard

If you are using a 3D press ST3042, set approx. 180° / 10min

PROCEDURE

Prepare graphics for printing on the cutlery handle, the print template for 3D is always at the spoon in the e-shop (std / kid's)
Kid´s cutlery 3D.pdf
Std cutlery 3D.pdf


Print your image, cut sublimation paper around the image and fix it on the cutlery handle (if you want on both sides)
Slide the shrink foil onto the cutlery handle - see. picture.
Remove the wire rack from the 3D oven and turn on the 3D oven. After reaching the temperature in the 3D oven, insert the wire rack with cutlery  ( pls use heat resistant gloves ) inside of the 3D. Due to the heat, the shrink foil is tightened tightly around the cutlery
(attention - if you place cold cutlery in the foil on the hot wire rack inside, foil may break at the point of contact )

After 10 minutes, remove the cutlery and it is best to cut and remove the foil with a small sharp knife (flat tongs can also help)

Use heat resistant gloves
Shrink foils are sold individually / whole package of 200 pcs

1846 Items
Loading...

Your cart

Unfortunately your basket is empty

Shipping 0.00 €
Total
no VAT
0.00 €
0.00 € with VAT
Loading...