HEAT SHRINK FOIL (BAG) / TRAVEL MUG 1200ml (20 x 40)

Shrink film for printing Travel Mugs 1200ml in 3D / oven
The length of the foil covers the entire length of the Travel Mug

The heat shrink foil is intended for printing :

* Travel Mug 1200ml

If you are using a 3D press ST3042, set approx. 170° / 5min

PROCEDURE

First remove the plastic handle from the mug (2x screws)
Print your picture, cut it out and attach it to a travel mug, then slide the shrink wrap over it - see picture

Heat the shrink wrap with a heat gun while simultaneously rotating the travel mug until the wrap wraps tightly around it. Do not bring the gun too close to avoid burning the foil.
If the sublimation paper is still slightly wavy on the object after fixing it with foil, tighten these areas with, for example, fixing tape.

After 7 minutes, remove the travel mug and preferably cut and remove the foil with a small, e.g., paring knife (flat pliers can also help). The foil can be removed more easily immediately after taking it out of the oven, while it is still hot - soft, but watch out for burns!

Use heat resistant gloves
Shrink foils are sold individually / whole package of 100 pcs