Travel tumbler - light blue lid

TRAVEL 17oz POLYMER TUMBLER - LIGHT BLUE LID

Double-walled tumbler with a colored lid in an elegant matte finish. There is a small hinged (flip-lock) closure in the upper screw cap, which hermetically closes the small drinking hole (see Fig. 3 positions), which is very practical, eg in a car
The tumbler has very good thermal insulation for both hot and cold drinks. It does not have the same properties as stainless steel thermoses, but 4 hours (see the lower graph) for which it will keep the temperature of the drink in the car, office at the event, etc., more than a long enough time.

SGS certificate - conformity with FDA
(PTMT - ink sublimes directly into the structure of the material, the object is not coated)

DIMENSIONS - WEIGHT

Diameter 67-95 / height 195mm 
Volume 17oz   500ml / weight app 228g
Max. height of printed image app. 150mm

PACKAGING

The tublers are sold individually
Case contains 24 tumblers / weight 6,5 kg
Packaging for one tumbler (sold separately): TBA

PRINT - TEMPERATURES - TIMES

The tumbler consists of 3 parts - an inner cup, an outer cup (for printing) and an upper lid. After printing the outer cup (while it is still warm), push the inner cup into the outer one in the direction of the orientation arrows (see pictures). After cooling, the inner and outer cup form a double-walled unit, to which the upper colored lid is screwed.

3D OVEN / ST3042
Use : Silicon Wrap - Mug11oz / 300ml 
Pull the sleeve onto the Cup from below, see picture
Check that there is no bend / fold - the sleeve must fit tight over the entire surface of the Cup.

Switch on both upper and bottom heating, 180 C / 7 min