Jig - standard cutlery

JIG STANDARD CUTLERY

Aluminum jig with recess for inserting 3 pieces of cutlery (printed on T-shirt press)

Dimensions 129mm x 129mm x 14mm
Cutlery spacing in the jig: 42mm
Weight 542g

* Print the image on the sublimation paper according to the printing template (printing all 3 cutlery at once)*
* Put the cutlery in the jig
* Cut the sublimation paper according to the end marks
* Fix the sublimation paper on the jig so that the horizontal edges of the sublimation paper are exactly with the edge of the jig. Very small part of the handle at the top and bottom must remain visible (vertical direction ) - to check that the cutlery does not move before closing the press (the cutlery has a vertical clearance of approx. 2 mm in the jig)

* Place the cutlery with the jigt in the middle of the press and cover it with a thin silicone.
If your T-shirt press does not allow greater vertical adjustment, remove the lower thick rubber from the press, which is about the same thickness as the jig, place the jig as shown (cutlery outwards) and place the second jig on the other side so that the upper heating plate does not tilt, ie that the press plate fits with the plane of the printed cutlery ( see pictures )

Set temperature 180 C / time 240 sec