Categories

3D Silicone Sleeve for plates

3D Rubber Bag for plates
3D Rubber Bag for plates
3D Rubber Bag for plates
3D Rubber Bag for plates
Previous keyboard_arrow_left
Next keyboard_arrow_right
3D Rubber Bag for plates
3D Rubber Bag for plates
3D Rubber Bag for plates
3D Rubber Bag for plates
Previous keyboard_arrow_left
Next keyboard_arrow_right

Silicone sleeve for printing of plates ø 20cm in a vacuum 3D press

9.40 € no VAT

9.40 € incl. VAT Not in stock

SILICONE SLEEVE FOR STANDARD SIZE PLATES

Only for standard 200 mm diameter plates

Insert the plate into the sllicone sleeve and connect the tube from the compressor to the upper outlet, see.the pictures

Attention:
* The silicone sleeve has a technological rib in the middle, for sure place a thin teflon below the sleeve / above the fixed sublimation paper so that the rib cannot be transferred to the print*

* The sleeve is made of thinner silicone, so thread it on the plate carefully (do not stretch the sleeve too far to the sides), it could tear the edge of the silicone !

Loading...

Your cart

Unfortunately your basket is empty

Shipping 0.00 €
Total
no VAT
0.00 €
0.00 € with VAT
Loading...